空气冷却器

D型系列空气冷却器(又称冷风机)是一种适用于各种冷库(如土建冷库或组合冷库)的冷却降温设备。D型系列空气冷却器有DL. DD和DJ型三种型式，分别适用于不同库温的冷库。它具有结构紧凑,重量轻,不占用冷库使用面积，库温均匀,效率高等优点，使冷库内贮藏的食品迅速降温,大大提高了贮藏食品的保鲜度。

D series air cooler (also known as cold air cooler) is a kind of suitable for all kinds of cold storage (such as cold storage or combined cold storage) cooling equipment.D series of air cooler are DL, DD and DJ three types of cold storage, which is suitable for different temperature. It has compact structure and light weight,Does not take up the cold storage area, Couvin uniform, efficient, so that the storage of food in the refrigerator to cool down, greatly improving the storage of foodFreshness degree.

产品用途

D型系列空气冷却器可与不同制冷量的压缩机组配套,用于不同库温的冷库中。作为制冷设备，其中DL型适用于库温为0°C左右的冷库，如保存鲜蛋或蔬菜的冷库; DD型适用于库温为-18°C左右的冷库,作为肉类、鱼类等冷冻食品的冷藏用; DJ型适用于库温为- 25°C的冷库，作为鲜肉或鲜鱼制品或调理食品的速冻用。

Application

D type air cooler can be compressed with different amount of refrigeration unit, used for cold stor-age in different temperature. As refrigeration equipment, which dl for Koon for about 0 DEG C cold stora-ge, such as eggs or vegetables cold storage preservation; DD genotype for Koon for about 18 degrees of Cold storage, used as a meat, fish and frozen food storage; DJ type applicable to Koon - 25 C cold stora-ge, as fresh meat or fish products or conditioning of quick-frozen food with.

产品特点

1、壳体采用喷塑工艺或轧花铝板并表面喷塑处理，有强烈的耐腐蚀性,外观美观大方。

2、盘管以新颖方式布置,以减小风测阻力,套片后,再通过液压涨管将铝翅片紧裹在铜管上,减小接触热阻,提高传热效率。

3.产品经试压后,再经过三氯乙烯在管内的清洗,以除去管内的油污、水份和氧化皮等。当用户充入制冷剂后不会出现由于系统内杂物油污而造成膨胀阀堵塞等故障。

4、选用专用的风机电机,耗电量小、风量大、噪音低、射程远,以保证潮湿低温状态下正常运转。

5、采用绝缘性强的U型管状电热管,电热管插入盘管内,间距分布及功率设计合理，融霜时间短,效果好。

6、采用槽型吊架,吊装方便。

7、出厂前全部经过保压充氮处理。

Features

1, the housing using spray technology or crimped aluminum and surface spray, strong corrosion resistance, elegant appearance.

2, the coil is arranged in a novel way to reduce wind resistance measured after set piece, and then up through the hydraulic pipe wrap in aluminum fins on copper tubes, reducing the contactResistance. improve heat transfer ffici-

3, the product after the pressure test, and then after trichlorethylene in the tube cleaning to remove oil, water and 0-xide tube and so on. When the user charge the refrigerant does not occur due to debris in the system caused by the expansion valve blockage of oil and other failures.

4, the choice of a dedicated fan motors, power consumption, air volume, low noise, long range, in order to ensure the normal operation at low temperatures and wet.

5, the use of insulation and a U-shaped tubular heating pipe, heating pipe inserted into the coil, the pitch and pow-er distribution design is reasonable, defrost time is short, the effect is good.

6, using slotted hanger for easy lfting.

7. the factory after all packing nitrogen treatment.